Sensory-scapes - Welcome floor marker

Installation instructions:

1. Thoroughly clean the floor surface, and make sure it is completely dry. We recommend wiping the surface area with rubbing alcohol or alcohol wipes. Make sure there is no residue and the surface is flat.
2. Position your decal in the space you like it. If you are placing multiple decals you may want to measure and centre them in proximity to other decals. Most decals are placed in front of doors, in this case place them relatively close to the threshold of the door.
3. With the backing on, tape the decal to the floor in the position you want it.
4. Peel back a small section of the backing paper and cut it away using scissors.
5. Adhere the section of the sticker with the removed backing to the floor. Use a squeegee or flat edge to remove any air pockets working from the centre out.
6. Remove the tape holding the sticker in position, Flip the sticker over and peel away the remainder of the backing.
7. Slowly roll the remaining exposed sticky edge onto the floor/surface using the squeegee to push out air bubble again, working from the middle out.